Evaporative cooling of porous tiles with seawater in a tropical climate with salty humid air

04/03/2019

Autores: Pan, Z. et Al

RESUMEN:

Buildings on tropical islands in the South China Sea are facing an overheating challenge. High-water-absorbency unglazed porous ceramic (UPC) materials could counteract heat gain by evaporation. Salty humid air and seawater in the marine environment lead to evaporative cooling differences from inland conditions. This research replicated a salty humid atmosphere with a stable concentration similar to the actual environment in a dynamic hot-humid climate wind tunnel (DHWT). The influence of salt in gas-liquid media on evaporative cooling is discussed. The results showed that the salt concentration of humid air in the wind tunnel can be controlled by adjusting the atomization rate and the concentration of the atomized liquid. Humid air and liquid with salt reduced the evaporation rate of the UPC tiles. The influence of salty humid air was generally less than that of seawater. In 6 mg/m 3 salty air, the total evaporative cooling effect decreased by 2.63% and 40.44% when saturated with fresh water and a 3.5% sodium chloride solution, respectively, relative to saturation with fresh water and evaporation in humid air without salt. In conclusion, sea salt in humid air and in the liquid phase reduced but did not eliminate the evaporative cooling effect of UPC materials. Seawater source utilization showed a significant benefit in cooling and water conservation aspects in coastal areas

Si desea más información póngase en contacto con el Centro de Documentación

Comments are closed.



ITC © 2011  |  T.+34 964342424  |   F.+34 964342425  |   info@itc.uji.es  |   Av. Vicente Sos Baynat s/n, 12006, Castellón de la Plana, Spain  |   Aviso legal  |   Protección de datos  |   Accesibilidad